TAJIMA TCMX 601, Руководство пользователя

Страница: 55 / 130

5-14
Functions that are frequently used
11.
Trace
Move the frame to check embroidery range.
It makes the frame move along embroidery range of design of which
data has been set.
1.
To call the screen......................................................
2.
Trace.................................................................. End
The machine will start tracing.
It is also possible to stop frame travel by the bar switch
or stop switch.
Switching the screen
Main screen..................
(twice)
Other setting • operation
Outline of trace...........................................................................
CAUTION
When performing this operation, do not put your
hands, etc. on the machine table. You could be injured
by moving frame.
It is not possible to perform tracing in the middle of
embroidery.
Outline of trace: p.5-13
!
List screen List screen
Press D1.
D1
5 Trace
or
The current needle position will be displayed.
Frame travel speed
-: Not to perform/Low: Low speed/High: High speed
1
2
D1
/Low/High
Needle Position
f
1
2
5 Trace
Low
Example: Low speed
E
A D2 F1 F6
Offset start position
6
1
2
3
4
5
7
Design start point
Offset start middle position
When offset is set
When repeat is set, the machine will trace whole designs
after tracing the first design only.
When data conversion or automatic offset is set, the frame
will move according to the setting.
1
3
4
5
6
7
8
9
2
10
JZ07