2. PRESENTATION
-
use 100m-300m of virtual wire). It leads the mower back to charging
station and the mower will take it as a wall when it is operating. It will get
on the virtual wire until it meets charging sheet which localed in front of
charging station, then it gets off virtual wire and starts cutting.
- Mower stops working if virtual wire has be cut or charging station is
out of power
If virtual wire has been cut off or it's out of sign, the mower must stop
working within 3 seconds. If the charging station is out of power, the
mower also will stop working within 3 seconds.
- Three steps to safe start the appliance
Three necessary steps to start the mower: firstly, connect virtual wire to
charging station and make sure it is in good connecting (virtual wire light
on charging station is colorless). Second, connect charging station with
power supply through charger and the charging station light is in green
color. Third, turn on the power of mower by entering the correct password
and choose operating pattern, the mower started.
- Overload protect
Each of the two blade motors and each of the two wheel driving motors
are monitored continuously during operation for any situation that may
cause these motors to over-heat. In the event this is detected, the mower
will stop operation.
- Fuse protect
There is a fuse hold under clamshell (top cover) next to charging jack, it
contains a one-time-use fuse in the event of a short-circuit or power
malfunction.
- Waterproof
Waterproof design, there is an inner cover under top cover which protect
inside parts from humidify.
- LED display
Virtual wire
The robot lawn mower can't operate without a virtual wire. (we suggest to
-
P11
-
6
.
Maintenance and storage
6. MAINTENANCE AND STORAGE
- During maintenance operations, use the individual protections indicated
by the Manufacturer , especially when intervening on the blade.
- Before performing maintenance operations, make sure that the robot
has stopped in safety conditions.
PROGRAMMED MAINTENANCE INTERVALS CHART
See “Robot
cleaning”
See “Blade
replacement”
If the fuse is burned
down
See “Fuse
replacement”
Robot
Carry out cleaning
See “Robot
cleaning”
6.1 Robot cleaning
1.Stop the robot in safety conditions.
2. Wear protective gloves.
Frequency
Component
Type of operation
Reference
Every week
Every month
Blade
Fuse
Clean and check the
efficiency of the
blade
If the blade is bent due
to an impact or if it is
worn-out, replace it.
-
P42
-
