NEOS3000A-3G COMBINED Ver. 1
Page: 4/12
For more change see below setting mode :
Setting mode :
(see our function code)
++++++++++++++++++++++++++++++++++++++++++++++++++
Note:
Every time when you need to change function code , it is necessary to proceed
the following steps :
---Before change function code--
1.
Please press setup mode "
＊＊＊＊＃
”
2.
Please press password code "1234#"(default)
3.
Now it’s ready for enter any code to change function code
++++++++++++++++++++++++++++++++++++++++++
Now you can change function code :
b) Q: If destination number start with 00xxx use PSTN.
A:
(Outgoing call by PSTN)
When our NEOS connect to PSTN, You don't need to setup this function
please dial directly.(If our NEOS only connect to telephone, it is like a mobile phone, every time
you dial , it will call out via GSM network) .
c) Q: If destination number start with 0xxxx use mobile network.
A:
(Outgoing call by GSM)
if you connect to PSTN , please See "Permissible Dialing" function code
"80xxx#" i.e. : enter " 80
ｘｘｘｘ＃
" is okay.
d) Q: If destination number start with 1,2, 3, .... Until 9xxxx use PSTN (local calls).
A:
(Outgoing call by PSTN)
When our NEOS connect to PSTN, You don't need to setup this function ,
please dial directly
e) Q: In case if I want to dial to 00xxxxx by using mobile network just for this call temporary),what
should I do?
A:
(Outgoing call by GSM)
If our NEOS connect to PSTN, Same "c" . enter 8000xxxx .
f) Q: In case if I want to dial to 012xxxx by using PSTN network just for this call (temporary), what
should I do?
A:
(Outgoing call by PSTN)
If you have setup above "c" ..USE PSTN line. It will cause facing problems,
you can find the first permission for 2 code are "01~09" numbers. Thus you need to delete "c"
(see"permissible dialing") and after finished you can set up this functions to enter "8012xxx" . You
can only choose one of them (c) & (f) when connect to PSTN.
All RESET back to FACTORY DEFAULT , PRESS 999 . (All functions will be back to
factory default)