Tait TM9100 Series P25, Руководство по установке, Страница: 20 / 40

20 Installing the Radio TM8100/TM8200 Installation Guide
© Tait Limited October 2012
Notice
Do not install the fuses until the installation is ready to be
checked. For more information, refer to "Checking the Installation" on
page 28 .
5. Insert each end of the negative wire into each of the fuse
crimp-terminals and crimp them to force the metal contacts onto
the wires.
6. Push the two crimp-terminals into the clear plastic fuse cover. Close
the cover while the next steps are completed.
7. Repeat steps 5 and 6 for the positive wire.
8. Connect the negative wire to the battery ground terminal.
9. Connect the positive wire to the battery positive terminal.
Notice
Do not install the fuses until the installation is ready to be
checked. For more information, refer to "Checking the Installation" on
page 28 .
3.6 Connecting a Remote Speaker
If a high-power remote speaker is
required, Tait recommends using:
■
TMAA10-06 high-power remote
speaker for >25W radios
■
TMAA10-03 high-power remote
speaker for 25W radios
The remote speaker is installed in
parallel with the radio’s existing
internal speaker. It can be installed at
some distance from the radio, or it can
be used to increase the volume of the audio from the radio’s existing internal
speaker.
If a different speaker is used, receptacles for the speaker pins of the power
connector are provided with the installation kit.
■
Connect the speaker to pins 2 (SPK–) and 3 (SPK+) of the power
connector described
on page 18 .
For more information, refer to the installation instructions provided with
the speaker, or to the relevant section of the service manual.
>25W 25W