TM8260 Installation and Programming Guide
Preparing the Installation
11
© Tait Limited
October 2014
2
Preparing the Installation
This section contains the following information:
■
■
Unpacking and Checking the Equipment for Completeness
■
Hardware and Firmware Compatibility
■
■
2.1
Installation Tools
The following tools are required to install the radio system:
■
drill and drill bits
■
5mm (3/16 inch) flat-bladed screwdriver
■
Torx T-10 screwdriver
■
Torx T-20 screwdriver
■
Pozidriv screwdriver
■
8 mm (5/16 inch) socket
■
wire cutters/strippers
■
RF connector crimp tool
■
fuse crimp tool
■
in-line RF power meter capable of measuring forward and reflected
power at the operating frequency of each radio.
2.2
Unpacking and Checking the Equipment for
Completeness
To install a dual-radio system, you require the following equipment. For
information on the version number of equipment required, see “Hardware
and Firmware Compatibility” on page 13.
■
2 x radio bodies, such as TMAB22-B100C and TMAB22-H600C.
■
2 x body remote interfaces (TMAC31-0T).
■
2 x radio body installation kits, appropriate for your required mounting
arrangement, and the radio’s transmit power and antenna connection.
Examples include the U-bracket installation kits TMAA03-01 (for 25W
radios with BNC connector), TMAA03-17 (for >25W radios with
mini-UHF connector), and TMAA03-22 (for >25W radios with BNC
connector), or the slide-in cradle installation kit TMAA03-18 (for 25W
radios with BNC connector).
