Taiden HCL Series, Инструкция по установке и эксплуатации

Страница: 15 / 22

HCL series Line Array Column Loudspeaker
Installation of HCL-1200 series, HCL-1400 series and HCL-1800
Explanation: wall bracket consists of a speaker bracket and a wall bracket.
Speaker bracket 1
PM6
×
12 mm screws 4
M6
×
70 mm screws 4 Wall bracket 1
Flat washers 4 Lock washers 4
Coupler Plate 1 PM6
×
25 mm screws 8, for HCL-1800U+HCL-1800D and HCL-2800F+HCL-2800B
1. Wiring: run the wiring between the amplifier and the location desired for mounting the loudspeakers;
2. Attach wall bracket to wall: secure the wall bracket to the wall according the following dimensions, please using a level to ensure the wall
bracket is straight. Use the appropriate wall anchors for attaching the bracket, the provided screws (M6
×
70 mm) are for hard wall such
as cement wall. Be sure that the slot feature is at the top.
Note: installation must be done by qualified persons using safe rigging standards, and please use all four screw holes for maximum
integrity and safety.
3. Attach speaker bracket to speaker: mount the speaker bracket to the speaker with four provided PM6
×
12 mm screws, lock washers
and flat washers.

HCL-1200: there are two optional mounting locations for attach speaker bracket, top and middle locations, as shown in the
following figure, and all the mounting locations support ±80 degree swivel (pan) and ±15 degree tilt angles. Middle mounting
location is recommended.
Toward down
Toward up
Top mounting location
Middle mounting location
14