-
2
-
3.5 Installation
This magnetic contact uses CR123A lithium battery, which is not installed in factory default. Please install it before use.
A. Open the cover by pressing the buckle at one end close to led.
B. Install CR123A battery on PCB, please pay attention to “+-”mark.
C. Test: pull the contact away from the transmitter, it will send a alarm signal to gateway, meanwhile, led on transmitter will flash.
D. Close the cover
3.6 Install Caution
A. If not drill on the wall, please use strong double side glue or other strong bonding agent to fix the magnetic stripe and
transmitter on the right place
B. Do not mount on the base-loose place, possible to be destroyed place or with strong magnetic interface(eg. Loudspeaker,
high voltage cable)
3.7 Precautions
There is a white triangle Δ in the surface of transmitter and receiver, keep them on the same level. All alarm happens, the led
indicator will flash red once and turn off.
5.Miscellaneous comments
Our wireless products are very reliable and tested to high standards, however, due to low transmitting power and limited range,
required by regulatory authorities, there are some limitations to be considered. It will course the panel to make alarm at any alarm
situation, following are some common examples
1. Voltage instability for the control panel
2. Under voltage of detector etc.
These problem are not so difficult to solve, if need help please contact the supplier
4.Maintenance
4.1 change battery
The working life of battery is about one year, change battery when the signal between the detector and alarm host become weak.
1. Open cover
2. Take out used up battery and put in new battery rightly.
3. Test battery, parallel move the magnetic from transmitter, then the control panel will make alarm information.
4.2 clean and fix the cover
The surface of the detector will be dusty when used for a long time, please use wet cloth to clean it.
