©COPYRIGHT 2005 TAHMAZO PRODUCTS PTE LTD
Tahmazo Products Pte Ltd
w:http://www.tahmazo.com
e:[email protected]
126 JOO SENG ROAD, #08-06
GOLDPINE INDUSTRIAL BUILDING.
SINGAPORE 368355
BRUSHLESS MOTOR
ER
2208
K
Step 11:
Solder the wires onto exposed
copper wires and use heat
shrink sleeves provided to
protect the wires.
Step 13:
Apply thin layer of epoxy over motor
core. Then fit the motor core and
connecting wires onto the aluminum
endbell. Ensure motor core is seated
completely into endbell. (See Figure 13)
Step 12:
Clean surfaces of motor core
and internal diameter of
aluminium endbell. Trial fit the
endbell into the stator.
Step 14:
Ensure that the
wires around
poles are not
protruding
above bearings.
(See Figure 14)
Apply light
grease over
bearings before
inserting the
motor case.
Step 15:
Place helical washer and circlip
over the shaft. This is to secure
motor and shaft.
You now have a brushless
motor according to your
requirement. A Tahmazo label
is provided for you to indicate
the KV or other specifications
of the motor.
WARNING:
Take extra care when inserting the stator into the motor
shaft as the pre-installed magnet are very strong.
§
§
§
§
§
Install only undamaged and balanced propellers.
Never touch, or allow any object to come into contact with the rotating propeller.
For their safety, keep all onlooker well away when preparing your model or connecting your batteries.
Switch on your transmitter first, check the position of the throttle stick (usually at the minimum position for safety), then
connect your battery pack to the speedcontroller.
A stopped propeller could result in damage to your controller and motor.
Safety:
This instruction sheet is subject to change without notice. Manufacter, guarantees the product to be free from defects in
materials or workmanship. This guarantee does not cover periodic maintenance and repair or replacement of parts due to
normal wear and tear, any adaption or changes to upgrade the product from its normal purpose, transport costs and all
risk of transport relating directly or indirectly to the guarantee of the product; damage resulting from the misuse including
installation or use of the product; repair undertaken by unauthorised persionnel or customer, accidents, lightning,
water,fire, improper installation or any cause beyond the control of the manufacturer;defect of the model into which the
motor is installed.
Warranty
Troubleshooting:
Motor stutters, Motor doesn't
start or gets to half throttle
and stutters
§
§
§
You have a poor solder joint on your terminators.
You have over-propped your motor
You have a short, eg. your terminations are touching some metal.
3
Instruction Manual
