XT-2 Reader Installation Manual & Data Sheet
Doc no. 10-407 02
© TagMaster
16 (26)
5.2.3.4 Mag-stripe Timing
The following values apply when all outputs are pulled up to 5V with 1k
Ω
resistors.
Table 7 Mag-stripe interface timing
Symbol Parameter
Min
Typ
Max
Unit
t
SU
LOAD to CLK setup time
0
µ
s
t
F
Fall time (all signals)
125
ns
t
R
Rise time (all signals)
5
µ
s
t
CL
Clock low
150
µ
s
t
CH
Clock high
150
µ
s
t
H
LOAD hold time after last CLK change
0
µ
s
≈
≈
t
SU
LOAD
CLK
DATA
≈
t
CL
t
CH
t
DH
t
H
t
R
t
F
Figure 7 Mag-stripe timing diagram
5.2.4 Power Supply, Group J31
Pin 1 is internally connected to pin 3 and pin 2 is internally connected to pin 4. The
purpose is to make it possible to feed power to any peripheral equipment. Use pins 1
and 2 for power supply connection.
Table 8 Power Supply, Group J31
Pin
Signal
Description
1
SPL
Positive DC supply input
2
RTN SPL
Negative DC supply input
3
SPL
Positive DC supply input, internally connected to pin 1
4
RTN SPL
Negative DC supply input, internally connected to pin 2
5.2.5 RS485 Serial Communication Interface, Group J41
The controller board has one RS485 serial interface for both 2-wire and 4-wire
communication. RS485 supports multi-drop serial networks. The communication can
be in both full duplex (4-wire) and half duplex (2-wire).
Note:
If the installation requires long cables or high data speeds it may be necessary to
use termination.
