Taga Taga 2.0, Руководство пользователя

Страница: 13 / 33

13
Step 9: Assembling the Cargo Compartment holders
1.
Position the holders on the front frame as shown and make sure the holes in
the holder are aligned with the hole in the frame
FIG 13
.
2. Insert the screw through the holes. Make sure the washer is close to the
screw head
FIG 13
.
3. Insert the nut onto the screw in the other side of the hole and hold it with
the wrench provided, while tightening the screw with the Allen key provided
FIG 13
.
4. Attach the front brake cable, which goes below the holders to the holders
using the zip tie provided and cut the remaining edge of the zip tie with
scissors
FIG 13
.
Cargo Compartment Assembly
Step 1: Assembling the Cargo basket
1.
Position the basket parallel to the metal frame as shown
FIG 14
. Make sure
that the flat surface, which is part of the basket, is positioned in the back, next
to the vertical metal square
FIG 14
. Make sure the rounded corners of the
basket at the front of the basket are parallel to the metal frame corners.
2.
Attach the basket to the frame using the double sided Velcro straps as shown
FIG 14
. Pay attention to the directions of the Velcro straps in the illustration.
3. The flat surface at the back of the basket should not be secured too tightly,
to allow space for the plastic frame and to avoid collision with the child seat
FIG 14
.
4. Attach the wooden floor to the basket with the Velcro straps on its bottom
FIG 14
.
Step 2: Assembling the plastic frame
1.
Position the plastic frame onto the metal frame as shown
FIG 15
. Make sure
that wider side of the plastic frame is in the front.
2. Insert the 4 screws to the bottom side of the frame and tighten them using
the Allen key provided.
FIG 15
Step 3: Assembling the Cargo compartment on the bike
1.
Hold the cargo compartment by its two handles, one on each side
FIG 16
.
2.
Slide the rear end of the cargo compartment onto the special holder on bike’s
rear frame (as shown), ensuring it is firmly secured.
FIG 16
3.
Lower down the front part of the cargo compartment so the metal brackets
insert into the slots in the plastic holders. Make sure that the holder handles
move back to their upward position as shown
FIG 17
. You should hear a
“click”.