Taga Harmony HTA-25B, Инструкция по эксплуатации

Страница: 11 / 16

11
Bass Regulator:
You can adjust bass output of the amplifier. The default: the knob is in the
center position : the marker on the knob in the vertical position. Turn the knob
counterclockwise (-) to decrease the amount of low frequencies. Turn the knob
clockwise (+) to increase the amount of low frequencies (+).
Treble Regulator:
You can adjust treble output of the amplifier. The default: the knob is in the
center position : the marker on the knob in the vertical position. Turn the knob
counterclockwise (-) to decrease the amount of high frequencies. Turn the knob
clockwise to increase the amount of high frequencies (+).
Input Selector:
You can select one of four available audio inputs (USB, CD, Bluetooth, AUX).
Headphones Connection:
When headphones (not supplied with this product) are plugged to the headphone input
(Headphones) the transmission of sound to the speakers is switched off. The REC
output is still active.
The volume of the headphones is regulated by the Volume Regulator.
All sound regulations (Bass / Treble) will affect the sound transmitted to the
headphones.
Note! Listening at high volume can cause hearing damage.
REC Output:
This output is used to record audio from the amplifier on an external device.
The output audio signal level is fixed (is not regulated by the Volume Regulator).
VU Meter:
The VU Meter is displaying a representation of the current signal level (it is affected by
Volume / Bass and Treble regulations).
Operation
Additional Information
Break-In
Your TAGA Harmony amplifier sounds great immediately after it is taken out of the
carton but as all hybrid amplifiers, this amplifier requires a “break-in” period to reach its
full sonic capabilities.
During the “break-in” period it is recommended to operate the amplifier at moderate
volume levels.
The first level of the “break-in” is reached after approximately 10 hours of play.
The optimal level of the “break-in” is reached after approximately 40 to 60 hours of play.
It is recommended to avoid one-time short periods of operation unless the amplifier
reaches the first “break-in” level. When the amplifier is turned on, it should operate for
around 4-6 hours.