Your PA10 needs to be connected to a high-quality, separate
stereo power amplifier (such as our 60P or 100P) or to a pair of
monoblocs
(1)
(such as our 125M).
Always switch off your system before changing any connections.
Using a good-quality, screened phono-phono audio cable,
connect the phono sockets marked
OUTPUT 1
(2)
left
and
right
on
the back of your PA10 to the corresponding inputs of your power
amplifier.
using a stereo
power amplifier
19
connecting power amplifiers
1. A ‘monobloc’ is a single-channel or mono power amplifier
2. You can use
OUTPUT 2
instead of
OUTPUT 1
. They are the same electrically
3. This diagram, and those that follow, are for illustrative purposes only; they are
not to scale and do not show all connections
This diagram shows a
PA10 connected to a
TAG McLaren Audio
60P stereo power
amplifier
(3)
out
out
in
hf
lf
left speaker
right speaker
hf
lf
The audio outputs are intended to connect the PA10 to a power
amplifier (such as our 60P). The low-impedance (100
Ω
) output is
buffered and will drive long cables or several inputs in parallel if
required.
OUTPUT 1
and
2
each consists of two phono sockets on the back
panel of your PA10, one for the
left
channel and one for the
right
(1)
.
Always use high-quality, screened cables for your connections.
audio output
sockets
18
outputs
1.
OUTPUT 1
and
2
are connected together in parallel
left
right
1
2
O U T P U T
GRA00046.1-[CA]PA10 13/03/01 10:41 Page 19
