8
13/10/2016
A Ground Breaking Company Since 1923
Drill Operation
Once you have set the correct depth set, mount the tractor and start drilling by turning
the Controller to RUN.
When you lift the drill at the end of a drilling run, the drill will automatically stop sowing
seed and then start when the drill is lowered.
In wet conditions, keep the jockey wheel clear of mud and debris.
End of Day
Follow the instructions on the page
‘Run to Empty’ in the RC300L Controller ver2.5x
Operators manual.
Removing Sponge Bar
Assemblies
Lift the flaps on either side of the seed/fertilizer hoppers and secure them in the raised
position using the locking tabs mounted on either side of hoppers in the centre.
Push down the Taege Snap locks and remove the sponge bars by putting sideways
pressure on the bar (away from the motor) until it clears the drive shaft.
Repeat the procedure for the other sponge bar/s.
