Tadiran Telecom Coral IPx Office, Руководство по установке и аппаратным средствам, Страница: 70 / 510

2-26
Hardware Installation Procedure Coral IPx Office Installation Manual
Eq
uipment Insta
llation
2
0. 0
General Guidelines
1. Connect a static dissipating wrist strap connector (not provided by the
manufacturer) to the cage and put on the strap. See
Figure 2-14 .
Figure 2-14 ESD Strap
Connection to Cage
2. Grasp the card with both hands and fingers on the card edge near the front.
3. Verify that the card is oriented correctly (the red diagnostic indicator on the
front side is oriented toward right of the card).
4. Align the edges of the circuit card with the card edge guides in the unit, and
gently slide the card straight into the card slot. A slight resistance is felt as the
multi-pin connectors on the circuit card mate with connectors on the
backplane. Push against the front panel until it is flush with the unit frame.
...................................................................................................
10 Peripheral Card Installation
Circuit cards contain static-sensitive circuitry and may be damaged or destroyed by
Electro-Static Discharge (ESD). Always wear the static dissipating wrist strap
connected to the unit. Hold circuit cards by their edges and handle with care.
Do not force the circuit card into the slot. If more than slight resistance is encountered,
remove the circuit card and examine the connectors for bent pins or interfering debris.
Never place a card in a slot other than the dedicated one.
See
Table 2-7
.