Tadiran Telecom Coral IPx Office, Руководство по установке и аппаратным средствам, Страница: 114 / 510

3-18
Initial Power-up Tests Coral IPx Office Installation Manual
Peripheral Interface Car
d Initialization
3
0
Preparing for Initialization
After the software has been installed and initialized:
1. In the expansion cages, verify that the power supply switch is in the OFF
position (turned downwards).
Verify that all power supply units within the expansion units are turned OFF. If
the expansion units are turned ON before the main unit, the peripheral cards
within the expansion units will not initialize properly.
2. Check the position of shared service and peripheral interface cards that will be
inserted into the system card cage. Observe any order previously directed or
any established convention of the distributor. See
Inserting a Peripheral Card into
the Main Unit, page 2-27
and refer to the following card placement diagrams:
„
Figure 2-15
Coral IPx Office Main Unit Card Placement on page 2-31
„
Figure 2-16
Coral IPx Office 1st Expansion Unit Card Placement on page 2-31
„
Figure 2-18
1st Expansion Cage IPx 500X Card Placement on page 2-32
„
Figure 2-19
2nd Expansion Cage IPx 500X Card Placement on page 2-33
„
Figure 2-20
1st Expansion Cage IPx 800X Card Placement on page 2-34
„
Figure 2-21
2nd Expansion Cage IPx 800X Card Placement on page 2-35
„
Figure 2-22
System with One FlexiCom 200 Expansion Unit on page 2-36
3. Verify that all peripheral cards in the expansion cages protrude from the cage
by approximately 1 inch (2.5 cm).
4. Attach the Program Interface (PI) device cable to the KB0 programming port
connector on the front side of the IPx Office unit.
...................................................................................................
2 System Initialization