Tadiran Telecom Coral IPx 800 Series, Инструкция по установке и справочник по аппаратной части

Страница: 180 / 400

5-54
Coral IPx 800 Installation Manual
I/
O RJ-
4
5 Co
n
n
ect
io
ns V
ia Re
ar P
a
n
el
Fo
r Cor
a
l In
te
rf
ace
Ca
rd
s
5
0
The external network connections to the PUGW card is made via one of the two
connectors available at the front and rear panels:
„
Front Panel : RJ-45 telephony connector (
Table 5-12
and
Figure 5-25 on page 5-39
)
„
Rear Panel : RJ-45 telephony connector (
Table 5-19
and
Figure 5-38
).
The PUGW card communicates via the RJ-45 connection on the:
„
cage rear panel for Coral IPx 800, 3000
„
card front panel for Coral IPx 4000.
Table 5-19
and
Figure 5-38
show the interface connections of the pins on the Coral
IPx 800 rear panel RJ-45 connector for the PUGW card. The interface connections are
the same for the front and rear panels.
Table 5-19 PUGW Rear
Panel RJ-45 Network
Interface Connections
Figure 5-38 PUGW
Rear Panel RJ-45
Interface Connector PIN
Assignment to the
LAN/WAN
For further information on how to make the connection, refer also to the
“Coral Voice Over IP Installation Manual”.
6 PUGW Card
Use one connector only.
Do not use the two connectors at the same time.
Pin # Nomination Function
Pin 1 Tx(+) Transmit Data (+) to Network
Pin 2 Tx(-) Transmit Data (-) to Network
Pin 3 Rx(+) Receive Data (+) from Network
Pin 4 not used not connected
Pin 5 not used not connected
Pin 6 Rx(-) Receive Data (-) from Network
Pin 7 not used not connected
Pin 8 not used not connected
4, 5, 7, 8
not
connected
1 2 3 4 5 6 7 8
1 - Tx+
2 - Tx-
3 - Rx+
6 - Rx-
RJ-45 Connector