Tadiran Telecom Coral IPx 500X, Инструкция по установке и справочник по аппаратной части

Страница: 171 / 400

External Connections
5-45
I/
O RJ-
4
5 Co
n
n
ect
io
ns V
ia Re
ar P
a
n
el
Fo
r Cor
a
l In
te
rf
ace
Ca
rd
s
5
0
The external network connections to the 2DT digital circuit can be made via the RJ-45
telephony connectors on the front and rear panels. This section describes the
connections to the rear panel. See
Figure 5-30
and
Figure 5-31
. For further information
on fabricating the network interface connection, refer to the Coral Service and Peripheral
Cards Installation Manual
.
2DT RJ-45 Network Connector Pinout
Table 5-14 2DT Network
Interface Connections
Figure 5-30 2DT RJ-45
Front and Rear Panel
Interface Connector PIN
Assignment
2 2DT Card (PRI-23, PRI-30, T1, 30T, or 30TM Configuration)
RJ-45 Pin # Nomination Functions
Pin 1 RxB Receive Data (ring) from Network
Pin 2 RxA Receive Data (tip) from Network
Pin 3 Shield Cable Shield, GND
Pin 4 TxB Transmit Data (ring) to Network
Pin 5 TxA Transmit Data (tip) to Network.
Pin 6 — Not Used
Pin 7 — Not Used
Pin 8 — Not Used
12 345678
RJ-45
Connector
1 - RxB
2 - RxA
3 - Shield (GND)
4 - TxB
5 - TxA
Due to logistical requirements, the card is labelled: "PRI-2DT” ,
on the front panel and on attached shipping documentation.