Tadiran Telecom Coral IPx 500, Быстрое руководство по установке

Страница: 32 / 86

1-22
Coral IPx 500 Installation Manual
General System De
script
ion and Installation
1
Assembling the Protective Cover
1. Open the door. See page 1-15, Opening the Door .
2. Insert the groove at the end of the top panel over the mating pin at the rear side of
the cage. See
Figure 1-17 .
3. Push down on the cover until it snaps into place on the cage.
Figure 1-17 Assembling
and Removing the
Protective Cover
Top Section
I/O (Champ) Connections
I/O connections to the peripheral cards are made via eight or ten female, 25 pair
AMP™ Champ™, or Amphenol
® Microribbon ® type connectors. Each connector
provides the I/O connections for one peripheral card. I/O connectors are mounted at
the top of each peripheral card. Interface cables exit from the rear panel of the cage.
I/O connections are only provided for peripheral cards installed in I/O card slots.
Mating male plugs should be industry standard, Amphenol
®
, AMP™ Champ™, or
similar.
I/O (RJ-45) Connections
The I/O connections of the following interface cards are established via RJ-45
connectors mounted on their top panel:
„
MCP-IPx
„
PRI-23ipx
„
PRI-30ipx
„
T1ipx
Pin
Groove