background image

Tadano electronic LOAD MOMENT INDICATOR system

TADANO AML-C monitors outrigger extended length and

(AML-C) including:

automatically programs the corresponding "RATED LIFTING

Control lever lockout function

CAPACITIES" table

Boom position indicator

Outrigger state indicator

Operator's right hand console includes transmission gear

Boom angle / boom length / jib offset angle / jib length / load

selector and sight level bubble. Upper console includes 

radius / rated lifting capacities / actual loads read out

working light switch, roof washer and wiper switch

Ratio of actual load moment to rated load moment

emergency outrigger set up key switch,

indication

jib equipped/removed select switch, eco mode switch,

Automatic Speed Reduction and Slow Stop function 

and air conditioning control switch. Slewing lock lever.

on boom elevation and slewing 

Working condition register switch

Load radius / boom angle / tip height / slewing range 

NOTE:  Each crane motion speed is based on unloaded

preset function

conditions.

External warning lamp

Tare function

Fuel consumption monitor

Drum rotation indicator (audible and visible type)

CARRIER SPECIFICATIONS

TYPE

 - Rear engine, left hand steering, driving axle 2-way

SUSPENSION

 - Front: Semi-elliptic leaf springs with hydraulic

selected type by manual switch, 4x2 front drive, 4x4 front and

lockout device. Rear: Semi-elliptic leaf springs with hydraulic

rear drive.

lockout device.

FRAME

 

- High tensile steel, all welded mono-box construction.

BRAKE SYSTEMS

 - Service: Air over hydraulic disc brakes on

all 4 wheels. Parking/Emergency: Spring applied-air released

TRANSMISSION

 - Electronically controlled full automatic

brake acting on input shaft of front axle. Auxiliary: Electro-

transmission. Torque converter driving full powershift with

pneumatic operated exhaust brake.

driving axle selector. 6 forward and 2 reverse speeds, constant
mesh.

TIRES

 - 23.5-25(OR)

4 speeds - high range - 2 wheel drive; 4 wheel drive
4 speeds - low range - 4 wheel drive

OUTRIGGERS

 - Four hydraulic, beam and jack outriggers.

Vertical jack cylinders equipped with integral holding valve. Each

TRAVEL SPEED

 - 31 mph (50 km/h)

outrigger beam and jack is controlled independently from cab.
Beams extend to 22' 11-5/8" (7.0 m) center-line and retract to

AXLE

 - Front: Full floating type, steering and driving axle with

within 9' 9-3/8" (2.98 m) overall width with floats. Outrigger jack

planetary reduction. Rear: Full floating type, steering and driving

floats are attached thus eliminating the need of manually 

axle with planetary reduction and non-spin rear differential.

attaching and detaching them. Controls and sight bubble located 
in superstructure cab. Four outrigger extension lengths are

STEERING

- Hydraulic power steering controlled by steering

provided with corresponding "RATED LIFTING CAPACITIES" for

wheel. Three steering modes available: 2 wheel front, 4 wheel

crane duty in confined areas.

coordinated and 4 wheel crab .

Min. Extension

  8' 1-5/8"   (2.48m) center to center

Mid. Extension

16' 4-7/8"   (5.0m) center to center

Mid. Extension

21' 3-7/8"   (6.5m) center to center

Max. Extension 22' 11-5/8" (7.0m) center to center
Float size(Diameter) 1' 7- 11/16" (0.5m)

ENGINE

Model 

Cummins QSB6.7 [Tier 4]

Radiator 

Fin and tube core, thermostat controlled

Type 

Direct injection diesel

Fan, in.(mm) 

Suction type, 9-blade, 28 (711) dia.

No. of cylinders

6

Starting 

24 volt

Combustion 

4 cycle, turbo charged and after cooled

Charging 

24 volt system, negative ground

BoreXStroke, in.(mm) 

4.212 x 4.882 (107 x 124)

Battery 

2-120 amp. Hour

Displacement, cu. in (liters)  409 (6.700)

Compressor, air, CFM(l /min) 

17.0 CFM (481) at 2,400rpm

Air inlet heater 

24 volt preheat

Horsepower (kW) 

Gross 270 (201) at 2,000rpm

Air cleaner 

Dry type, replaceable element

Torque, Max. ft-lb (Nm) 

730 (990) at 1,500rpm

Oil filter 

Full flow with replaceable element

Capacity, gal.(liters)

Fuel filter 

Full flow with replaceable element

Cooling water 

7.4 (28)

Fuel tank, gal.(liters) 

79.2 (300), right side of carrier

Lubrication 

4.0 (15)

Cooling 

Liquid pressurized, recirculating by-pass

Fuel 

79.2 (300)

DEF

10.0 (38)

3

Содержание GR-500XL













Отзывы: