TAD Evolution One TAD-E1TX, Руководство пользователя

Страница: 6 / 40

6
Installation of Spikes
The installation surface can be securely established by using
spikes.
Spikes are screwed into an aluminum base screw holes, which
are positioned at three locations on the bottom surface of the
cabinet.
Installation can be performed with no rattling of the installation
surface and requiring no fine adjustment of spike heights, by
providing support at three locations.
Once the installation location is decided by referencing the
section about Choosing Where To Place The Speakers on page 7,
install the spikes and the tumble prevention spikes.
1. Screw in spikes at three locations on the bottom surface of the
aluminum base (two in front and one in back).
2. Adjust the length of the fall prevention spikes to ensure that
there will be no rattling, then tighten them with nuts.
3. Place spike receivers at locations where spikes will be
positioned, then place the speaker on top of the spike receivers.
・
Place the speaker on top of something that would
not scratch it, such as a soft cloth, to perform
installation of the spikes.
・
Place spike receivers with the center indentation
facing up, as shown in the diagram below.
・ Using spikes without using spike receivers can
potentially leave scratches on the surface where the
speaker is installed, such as the surface of the floor.
CAUTION