tactio ALTERA-04G, Руководство пользователя

Страница: 7 / 40

ALTERA-04G
5
2.4 Hardware installation
This section describes how to connect and configure the ADSL2+ Router.
Step 1. Connect the ADSL Line
Connect the router directly to the wall jack using the included ADSL cable.
Step 2. Connect a Workstation to the Router's LAN port
There are two methods to connect the router and workstation. The one use the crossover Ethernet
cable to connect directly between them. The other use straight Ethernet cable to connect router with
hub (or switch), then go to the workstation.
Step 3. Connect the Power Adapter to the Router
Connect the power adapter to the port labeled POWER on the rear panel of router.
Step 4. Connect All Cables to the Network
The procedure for connecting cables differs depending on whether or not your telephone equipment is
connected to a POTS splitter.
POTS Splitter Configuration (ADSL over POTS)
A POTS splitter separates data signals from voice signals on your telephone line. The POTS splitter
works by running a separate data line from the voice line, so that the ADSL router has a dedicated
cable for data transmission. Figure 2-3.1 and 2-3.2 shows how to connect all cables to the Router.
Figure 2-4.1 Router Connected through a POTS Splitter
Note: The POTS splitter may also be installed on the outside of the house adjacent to the telephone
network interface device (NID).
Figure 2-4.2 Router Connected through several micro-filters