Low Profile Tri-Fold Hard Tonneau Cover
TO REDUCE RISK OF SERIOUS
INJURY OR PROPERTY DAMAGE:
READ ALL SAFETY MESSAGES
AND UNDERSTAND ALL INSTRUCTIONS AND PROCEDURE NOTICES BEFORE
ATTEMPTING TO INSTALL OR USE THIS PRODUCT.
RISK OF EYE INJURY! SAFETY
GLASSES MUST BE WORN AT
ALL TIMES WHILE INSTALLING
OR MAINTAINING THIS PRODUCT. DO NOT USE IF DAMAGED
.
DO NOT EXCEED RATED WEIGHT
CAPACITY OF TONNEAU COVER.
DO NOT EXCEED RATED WEIGHT
CAPACITY OF TRUCK. REFER TO
TRUCK’S GROSS VEHICLE WEIGHT RATING.
PARTS LIST
A. Tonneau Cover - (x1)
B. Left Side Rail - (x1)
C. Right Side Rail - (x1)
D. Front Bolt - (x2)
E. Drain Tube - (x2)
F. Foam Seal Tape - (x1)
G. Front Support Plate (Including Bolts) - (x2)
H. Side Rail Locking Tongue - (x2)
I. Clamp Assembly - (x4)
J. Allen Wrench - (x1)
K. 17MM Wrench - (x1)
REQUIRED TOOLS
Safety Glasses
Allen Wrench
17mm Wrench
A.
B.
C.
D.
E.
F.
THE WARNINGS, CAUTIONS,
AND INSTRUCTIONS
DISCUSSED IN THIS
INSTRUCTION MANUAL CANNOT COVER ALL POSSIBLE CONDITIONS OR
SITUATIONS THAT COULD OCCUR.
G.
H.
I.
J.
K.
Installation & Use Instructions:
For Part # 72074-8000/72074-
8001/12074-1000
INSTALLATION
Looking at the front rail of the truck bed near the cab,
determine if the truck bed side rails are higher than the
front edge of the bed. If the rails are higher that the front
bed rail, then use the foam seal tape on the front edge of
the bed to fill gap. Measure the length of the rail and cut
the foam seal tape to length. Peal the backing from the
foam seal and place on the full length of the rail. (Fig 1)
FIG 1
STEP 1
