LE-1 Flashlight – User Guide | 6
Changing Modes
– The light has 4 operating modes:
LOW (20%), MEDIUM (50%), HIGH (100%), or STROBE.
Mode selection is performed from the ON state only.
Once the light is ON, half-presses and releases of the
switch will cycle through the modes.
Mode-Memory
–
(if programmed)
– When the light is
powered ON, it will use the mode that was in-use
when the light was previously powered OFF.
NOTE:
The LE-1 is programmed by default to power
ON in HIGH mode every time. However, the LE-1
may be easily programmed to use mode-memory
by following the User Programming instructions.
Light-NOW
TM
– At any time, two or more rapid
(under
.5 seconds)
full-clicks of either switch will turn the light
ON using HIGH mode. The Light-NOW function does
not affect the mode-memory
(e.g. if the light is in
STROBE mode, and Light-NOW is activated, STROBE
mode will still be stored in memory if the light is
powered OFF)
. Continuously clicking a switch rapidly
will always result in the light being powered ON in
HIGH mode.
