7
included with those cords. To properly assign control of the aircraft to the teacher / student when using two
Tactic brand transmitters for training, follow these steps in order:
1.
Link the teacher’s Tx to the receiver inside the aircraft as explained on page 10. Remove power from
the Rx, then the Tx.
2.
Connect the student’s Tx to the teacher’s Tx with the appropriate trainer cord.
3.
Turn the student’s transmitter power switch ON.
4.
Turn the teacher’s transmitter power switch ON.
5.
To transfer control of the aircraft to the student, pull the teacher’s trainer switch and hold. Release the
switch to immediately return control of the aircraft to the teacher.
6.
When the training session has ended and power has been safely removed from the model, disconnect
the trainer cord.
WIRELESS TRAINER
This option allows for communication with another Tactic Tx by wireless means, and can function as the
teacher or student’s Tx. This function is not compatible with other brand radios.
1.
Link the teacher’s Tx to the receiver inside the aircraft. Remove power from the Rx, then the Tx.
2.
The student must use a separate Tactic Tx with wireless trainer function.
3.
Place both transmitters within 1 meter of each other, with the throttle stick for each Tx in the idle position.
4.
Turn the student’s Tx power switch ON.
5.
Pull and hold the teacher’s Tx trainer switch, and then turn the teacher’s Tx power switch ON.
6.
The LED on the teacher’s Tx will fl ash 3 times to indicate it has linked to the student’s Tx.
7.
Release the trainer switch on the teacher’s Tx.
8.
Once both transmitters are linked together, power can be applied to the Rx to prepare for fl ight. Make
sure both transmitters are kept within 15 feet of each other at all times while training.
9.
To transfer control of the aircraft to the student, pull the teacher’s trainer switch and hold. Release the
switch to immediately return control of the aircraft to the teacher.
10.
When the training session has ended and power has been safely removed from the model, turn OFF
the power switch of both transmitters. This will break the wireless link between both transmitters. Return
to step 1 above to re-establish the wireless link for additional training.
The TTX810 includes elevon and v-tail mixing functions to
be used specifi cally with airplanes. If not using one of these
mixes or the TTX810 will not be used to control an airplane,
skip to the next section.
The default setting for all mixing will be “off”, meaning all
channels will function independently of each other until a mix
has been activated. To change the mix setting:
1.
With the Tx power switch off, move the right stick to
the bottom-right corner, the left stick to the bottom-left
corner, and hold in these positions.
2.
Turn the Tx power switch ON.
AIRPLANE ELEVON and V-TAIL MIXING
