Tactic TTX600, Инструкция по эксплуатации

Страница: 5 / 24

5
at the same time (not separately). With the switch in one position, each channel’s
servo will be capable of rotating through its full travel range (100%). Moving the
switch to the opposite position will limit the rotational range of each channel’s servo
to 60% of its maximum rotational range. Placing the dual-rate switch in one position
can allow for better control of the model while on the ground, at low altitudes, or
while performing certain maneuvers. Moving the switch to the opposite position can
allow for optimum control of the aircraft in mid-fl ight.
ADJUSTABLE STICKS
The length of both gimbal sticks
can be adjusted as desired.
Loosen the set screw inside
the center of the stick with a
2mm hex wrench. Rotate the
stick end counter-clockwise to
lengthen the stick, or clockwise
to shorten the stick. Once the
desired stick length is found,
tighten the set screw with the
hex wrench.
CHARGE JACK
WARNING!! Do NOT attempt to recharge alkaline batteries! The
charge jack should ONLY be used if rechargeable cells are used
in the transmitter.
The TTX600 includes a built-in charge jack for convenient recharging of NiCd or
NiMH batteries, and is compatible with charge leads designed for Futaba
®
brand
transmitters (HCAP0101). This jack is NOT compatible with charge leads for Hitec
®
,
Airtronics
®
, JR
®
or Spektrum
®
radios.