1
TTX410, TTX610, TTX810 Radio Mode Changes
These instructions describe how to change the stick mode on Tactic brand
TTX410, TTX610, and TTX810 transmitters. Changing modes requires
mechanical adjustments inside the transmitter and electronic confi guration
changes. Failure to follow these instructions properly can result in permanent
damage to the Tx and void the warranty. Contact Hobby Services if you do not
feel comfortable making such adjustments without damaging the radio.
For safe operation and best results, it’s strongly recommended
to read these instructions completely before use.
These Tactic radios can be changed between stick mode 2 and stick mode 1.
Most radios for use in the United States are produced with stick mode 2
confi guration. The diagram here shows the difference between the two
modes. The locations of the aileron and rudder controls are the same for
radios on mode 2 and mode 1. However, the locations of the throttle and
elevator controls will alternate when changing between mode 2 and mode 1.
Throttle is on the left stick for mode 2, but on the right for mode 1.
Follow these steps to change the radio’s electronic confi guration from mode 2 to mode 1:
1. With charged batteries inside the Tx, start with the Tx power switch in the
OFF position.
2. Press the up/down trim button on the RIGHT gimbal to the up direction and
HOLD in this position.
3. Turn the Tx power switch to the ON position. The Tx should sound a unique
set of beeps very rapidly (one high and three low tones) to indicate the
throttle control has moved to the right stick and right trim lever, and the
elevator control has moved to the left stick and left trim lever.
4. With the transmitter linked to a Tactic receiver and servos connected to
channels 2 and 3, make sure both the stick and trim controls were swapped
for the throttle and elevator controls.
5. Turn the Tx power switch off, then back on to confi rm the radio held the stick mode change.
6. If the controls for the throttle and elevator channels did not alternate repeat steps 1-4 above.
Follow these instructions to change the radio’s electronic confi guration from mode 1 to mode 2:
1. With charged batteries inside the Tx, start with the Tx power switch in the
OFF position.
2. Press the up/down trim button on the LEFT gimbal to the up direction and
HOLD in this position.
3. Turn the Tx power switch to the ON position. The Tx should sound a unique
set of beeps very rapidly (one high, and three low tones) to indicate the
throttle control has moved to the left stick and left trim lever, and the elevator
control has moved to the right stick and right trim lever.
4. With the transmitter linked to a Tactic receiver and servos connected to
channels 2 and 3, make sure both the stick and trim controls were swapped
for both the throttle and elevator controls.
5. Turn the Tx power switch off, then back on to confi rm the radio held the stick mode change.
6. If the controls for the throttle and elevator channels did not alternate repeat steps 1-4 above.
LEFT
STICK
Rudder
Mode1: Elevator
Mode2: Throttle
Mode1: Throttle
Mode2: Elevator
Aileron
RIGHT
STICK
NORMAL STICK CONFIGURATIONS
ELECTRONIC STICK MODE CHANGE – MODE 2 TO MODE 1
ELECTRONIC STICK MODE CHANGE – MODE 1 TO MODE 2
™
