3. Use finger to keep the cable held in position around the Cable Retainer
Boss. Press the Cover to the Base so that the Release Tabs align with
the Release Tab Holes. Make sure that the Tabs are locked in the Holes.
SHIELD INSTALLATION
1. Clean the surface of the shield where the Shield Light Cable Organizer
will be placed.
2. Remove the protective plastic from the back of one of the provided 3M
Reclosable Fastener (P/N 51-030). Place it on the back of the shield at
the desired location. Press firmly to adhere the Reclosable Fastener to
the rigid shield.
3. Remove the protective plastic from the back of one of the provided 3M
Recloasable Fastener (P/N 51-030). Place it on the Cable Organizer Box
(see the following page).
4. Then, place the Cable Organizer Box onto the back of the shield (at
desired location where Reclosable Fastener was installed) and firmly
press down, joinging the two parts. Ensure the strips are perpendicular
to each other to prevent detachment.
