Squeegee:
Every week, check the blades of the squeegee and
wash them carefully. Then replace them in the correct working
position
(see above
). If drying is not perfect even after the unit
has been cleaned, replace any blades which are excessively
worn. If the squeegee does not pick up enough water or
streaks, lift and wipe off the blades. Inspect the squeegee vacu-
um path for obstructions.
The pad driver or brush must be in good working condition
because it is the component which removes the dirt.
To replace the block, pad or brush:
• Turn off the machine by placing the key in the off
position
• Lift the brush up by turning the knob
M9
to the off
“O” position
• Open the spring lever
M15
or fold up the vinyl
splash guard. Access from your right side, facing the
front of the scrubber.
• Rotate the brush by hand until the
M19
spring
rings are reached. Closing the
M19
spring rings
together by fingers
(like scissors)
drops the brush.
• Rotate driver/brush 180° and firmly pull it out from
the scrubber.
A selection of brushes for specific purposes is available. Pad
drivers should be installed with the chosen pad.
B l a c k
for strip-
ping,
G r e e n
for deep scrub,
B l u e
for cleansing and
R e d
for light
s c r u b .
Water collection tank:
This tank should be cleaned every
week.
1 ) Lift and lock the lid.
2 ) Remove the vacuum motor straps
M13
and lift the
vacuum motors out.
3) Thoroughly clean the filter or replace with a new filter.
4) Remove the float cage assembly and clean off the float ball
and assembly. Inspect free movement of the float ball.
5) Thoroughly flush out the tank by spraying water into the
tank through the openings allowing the drainage through
the valve or sludge port
M2
. The sludge door may be
removed by unscrewing the 2 knobs.
6) Before replacing the door clean the door housing and
the gasket
M28
.
7) Carefully replace all components and make sure the
gaskets are seated.
Batteries:
Check the level of the electrolyte liquid by carefully
removing plugs from top of battery and topping off with distilled
water, when the level drops below the plates of the battery.
Keep the batteries clean and dry with antistatic cloths. When
charging the batteries lift the top lid of the machine to allow the
gas which is generated to escape.
This gas can cause explo-
sions in closed environments
and, therefore, it is advisable
to carry out battery charging in well-ventilated environments.
- 6 -
