6
TROUBLESHOOTING
Burnisher tends to move to the right.
• Do not lift up on handle while operating the burnisher.
• Do not operate with the handle set too high. Recommended handle height is from your waist
with your arms extended forward.
Machine will not start.
• Plug is broken or has a loose contact. Replace.
• Switch is defective. Replace.
• Rectifier is defective. Replace rectifier.
Prevent circuit overload.
• Do not spray buff with the C1600-3. Apply a restorer such as Powr-Flite’s Escalate, allow to
dry, then burnish
• Check the pad and change it if it is rough or dirty.
• Check area being burnished for cleanliness, area should be damp mopped, scrubbed or
swept with treated broom.
• Operator should not continually force the machine with handle pressure.
• Operator should not try to operate burnisher in a side-to-side motion.
• Eliminate any extension cord that is smaller than 12/3 wire or greater than 25 feet in length.
Unplug anything other than the machine from the circuit or locate another circuit.
