1 channel RF Receiver 230Vac for RF thermostats RF Basic, RF
Digital, RF Week.
TECHNICAL CHARACTERISTICS
MODES DESCRIPTION
-
Radio frequency RF receiver (868 MHz) for water floor heating
systems controlled by actuators.
-
Personal code,
thus a clear allocation to the thermostat is ensured.
-
Equipped with a push button to select AUTO, MANUAL or RF INIT
mode.
-
To be used only with ours RF thermostats RF Basic, RF Digital, RF
Week
LED INDICATOR
RADIO CONFIGURATION MODE
1. Install and plug the receiver. Then press the receiver push button during 4
seconds, the Green LED should lit up indicating that the receiver is now in radio
configuration mode (
RF INIT
) waiting for a thermostat configuration address.
2.
Please refer to the thermostat leaflet for enter the thermostat in “RF Init” mode.
3. Verify that radio signals are correctly received by the receiver. On the receiver, the
Green LED should blink at each radio signal received from the thermostat.
4. Exit the radio configuration mode on the thermostat. (Please refer to the thermostat
leaflet)
5. Now starting up your installation in AUTO mode.
Yellow
Red
Green
0
0
0
Automatic mode, HEATER stopped
0
1
0
Automatic mode,
HEATER operating
1
0
0
Manual
mode OFF forced
1
1
0
Manuel
mode
HEATER forced
0
or
1
0
or
1
quick flash
Waiting for initialization
0
or
1
0
or
1
1
Waiting for a
configuration
signal (cf. configuration)
0
0
slow blink
ERROR see repair sequence bellow:
Repair instructions
- Verify the emitter batteries.
- Verify the emitter/receiver range.
- No perturbation by an apparatus at less than 50cm of
the receiver.
- No perturbation by an apparatus on the 868 MHz
frequency (continuous transmission).
By pressing on the push
button
nothing happens
- Verify that the receiver is correctly connected
- Verify main power supply (230VAC)
Manual Mode LED.
(Yellow)
Heating LED.
(Red)
RF LED.
(Green)
Mode push button
AUTO Mode
Manual Mode
(Heater forced)
Manual Mode
(Stop forced)
Press button
during 4sec
Press button
Press button
Press button
RF init
Press button
Operating temperature
0°C - 50°C (32°F
– 122°F)
Electrical
Protection
Class II - IP44
Power Supply
230Vac 50Hz
Radio frequency and
Receiving zone
868 MHz, <10mW.
Range of approximately 100m in open space.
Range of approximately 30m in residential environment.
certifications
CE. EN 300220-1, EN 301489-1
(Radio frequency certifications)
Output
Relay 12A 250Vac
NOVASTAT RF MINI (RT-RFK) - USER GUIDE
GB