13
E.3 Commissioning help
E.4 Free commissioning
If you decide not to use the commissioning help, you should make the necessary
settings in the following sequence:
- Menu 4.
Settings, all values
- Menu 3.
Special functions if additional changes are necessary
Finally, menu 2.2 under operating mode “Manual“ should be used to test the switch
outputs with the consumers connected, and to check the sensor values for plausibility.
Then switch on automatic mode.
order, and provides brief descriptions of each parameter in the display.
Pressing the “esc” key takes you back to the previous value so you can look at the
selected setting again or adjust it if desired. Pressing the “esc“ more than once takes
you back step by step to the selection mode, thus cancelling the commissioning help.
Finally, menu 2.2 under operating mode “Manual” should be used to test the switch
outputs with the consumers connected, and to check the sensor values for plausibility.
Then switch on automatic mode.
The fi rst time the controller is turned
on and after the language and time
are set, a query appears as to whether
you want to parametrise the controller
using the commissioning help or not.
The commissioning help can also be
terminated or called up again at any
time in the special functions menu. The
commissioning help guides you through
the necessary basic settings in the correct
Parametrisation
Caution
Observe the explanations for the the individual parameters on the
following pages, and check whether further settings are necessary for
your application.
Caution
Observe the explanations for the the individual parameters on the
following pages, and check whether further settings are necessary for
your application.
