OPERATION & DEPLOYMENT
11
Once ShadeFin is securely attached to its mount, follow these instructions for setup.
FIGURE B
FIGURE C
FIGURE D
0
5
25
75
95
100
SF-pull assy
Monday, September 14, 2020 9:22:07 AM
1)
To set up your ShadeFin, pull down on one of the front arm
release buttons inside the body while simultaneously pulling out
the front arm on the same side (Figure B). Do not pull the arm to
its fully locked position yet. Repeat this process on the other
side of the ShadeFin.
2)
Once both of the front release buttons have been pulled and
the front arms released, pull the shade fabric that is tucked
along the sides of the body out loosely. It is normal for the fabric
to hang loose at this step.
3)
Moving to the back of the ShadeFin, grip the ends of the back
arms and pull them straight out to their stopping point in the
housing (Figure D).
NOTE: Ensure arms are fully extended before spreading open.
4)
Spread the back arms open. Make sure the arms stay fully
extended.
5)
When the back arms are fully open, the root of the arms will
straddle the vertical support posts (Figure C).
6)
Return to the front of the ShadeFin.
7)
One at a time, pull on either front arm to spread it outboard to its
fully locked position. Both of the front arms should lock into
place. It is normal to apply some pressure to lock the arms. You
will hear and feel a small “click” when the arm engages into the
locked position.
8)
Enjoy your ShadeFin!
[email protected]
https://tacomarine.com/technical-support
Tech Support:
