4 / NEPTUNE III
1. Carefully unpack the frame and cushion assembly. Use care not to scratch the anodizing on
the frame with any sharp object.
2. With the frame sitting upright, place the mounting blocks (D) over the holes on the rear of
the top ring and align the holes.
3. Place the seat cushion (B) on top of the ring. Make sure the seat cushion is centered left to
right on the frame.
4. Install the four (4) #12 screws (F) into the cross braces on the front of the leaning post. The
screws should self tap into the backer board on the seat cushion.
5. Install the two (2) 2-1/4" x #12 screws into the rear holes passing through the mounting
blocks (D). The screws should self tap into the backer board.
6. Install the Leaning Post in the appropriate position in the boat and mark the hole positions.
It is recommended to use new drill bits to drill heads and for a secure seal use marine sealant
(not included).
7. If you are using a cooler, place it under the leaning post. Place the cooler block (G) at the
front center edge of the cooler. Make sure there is adequate room to use the footrest. Screw
the block in with the screws provided.
ASSEMBLY
INSTALLATION
Clean any dirt or packing debris from accessory splines.
REFER TO FIGURE 1 (P. 3)
WARNING
• It is very important that the leaning post is firmly attached to the deck to prevent injury. Consult your marine
professional for recommendation on proper backing plates and thru-bolting for solid installation.
• Be sure not to drill through wiring, fuel tank or hoses.
BACKREST, GRAB RAIL (I)
(Only available with L10-2010 Leaning Post)
Remove the eight (8) screws holding on the clamp covers.
Place the welded portion of the clamp against the rear leg
approximately 1/4" below the top ring. Install the clamp covers
starting all bolts first before tightening down the clamp. If you
have purchased the optional backrest, center the cushion left
to right on the rear support bar. The top of the cushion should
be approximately 1" higher than the top of the rear support
tube. Fasten with the self-tapping screws provided.
OPTIONAL ACCESSORIES INSTALLATION
ROD HOLDERS (H)
(Poly Rod Holders included with L10-2005 Leaning Post,
Aluminum Rod Holders included with L10-2010 Leaning Post)
Remove the mounting bolt from the rod holder and apply a
small amount of marine grade sealant (not included) to the
inside of the rod holder spline. Install the rod holder at the
desired angle and align the bolt hole with the groove in the
male spline. Re-install the bolt and tighten.
