Taco Marine NEPTUNE II, Руководство по установке

Страница: 4 / 8

4 / NEPTUNE II
1. Place the side frames on the deck (or a flat place).
2. Pre-assemble the cross bar, rod rack and D-ring using the screws, and/or washer, and/or
locknut, but don't lock it tight (pre-assemble only).
3. Push down the side-frame keeping the four (4) pads on the same level.
4. Assemble the footrest and tighten securely, keeping the two (2) sides parallel and the four
(4) pads in the same level.
5. Tighten the rod-rack again checking that the four (4) pads are at same level.
6. Tighten the D-ring and make sure it seats properly on the four (4) plastic caps.
7. Assemble the hinge to the seat cushion. Screw the four (4) flat head screws down evenly.
8. Loosen the cross bar and install the hinges as per diagram. Re-install the cross bar and
tighten to the side frame.
9. Check the rod-rack and adjust the angle. There are three (3) angles available with (three) 3
position holes.
10. Check for proper alignment of all components and tighten screws.
11. Install the leaning post to the deck in the appropriate position and secure.
12. Place the softpak storage bag within the D-ring, under the seat cushion. The key ring should
be in the back. Secure in place with the Velcro flaps around the frame.
13. Attach the cooler and eye strap on the rear legs.
14. Assemble the backrest (optional item). When installing optional backrest, use additional
liners provided and glue in place.
ASSEMBLY
INSTALLATION
Clean any dirt or packing debris from accessory splines.
REFER TO FIGURE 1 (P. 3)
WARNING
• It is very important that the leaning post is firmly attached to the deck to prevent injury. Consult your marine
professional for recommendation on proper backing plates and thru-bolting for solid installation.
• Be sure not to drill through wiring, fuel tank or hoses.