digiDL-B / BT - Installation
DigiDL-B / BT Installation Guide
Page - 10
Enhanced Cable form (see page 10 for other cable options)
Place the
manufacturers
WHITE, YELLOW and
RED (if present) plugs
in our multi plug.
Remove the manufacturers
WHITE, YELLOW and RED (if
present) plugs and replace
with those of our DDL-ETC
cable as shown.
CAN + PWR;
Place in digiDL-B / BT
Fig 4.
Fig 3.
In the case of digiDL-BT attach
the GSM and GPS cables as
labelled. These are a screw fit
with a clockwise thread.
In the case of digiDL-B attach
the short antenna to the GSM
connector by screwing on
clockwise.
Manufacturers RED
Plug fits here if
present. Otherwise
you must leave the
RED terminator plug
in place.
DigiDL-B / BT Installation Guide
Page - 11
digiDL-B / BT LED indicators
Fault finding hints
Ignition is ON but GREEN LED OFF, possible causes -
1.
CAN-Bus C (RED PLUG) connector is not connected correctly
2.
The Tachograph may not be of the correct type (see pages 4-5)
3.
Manufacturer may not have enabled the Secondary CAN-Bus (CAN2) (see
Page 8). This is common for DAF vehicles.
IMPORTANT! - digiDL-B / BT placement information: please make sure you do
not place the digiDL-B / BT too close to other comms devices. Preferably place
the unit flat with the antenna closest to an exterior panel as possible. In the
case of digiDL-BT the GPS antenna should preferably be in view of the sky.
Please refer to pages 24 and 25 for additional troubleshooting should the
digiDL-B / BT BLUE Led remain flashing when the ignition is ON.
Power Status CAN-Bus C Status
Connectivity
Fig 5.
LED
ON
OFF
Flash
P
Power Okay
No Power
Power okay and a Task is in progress
C
CAN okay
No CAN
Infers intermittent CAN connection or
CAN2 programming correction required.
W
Comms okay
No Comms
Slow: GPRS negotiation. Fast: no server
G
GPS Okay
No GPS
GPS Lock pending
GPS Status
digiDL-BT only
Содержание digiDL-B
Страница 1: ......
