TAC AB, 1999-08-18
0-004-7516-1 (GB), 3:1 (10)
TAC Xenta 102 Handbook
Installation
3
Installation
3.1
Mechanical installation
3.1.1 Fitting
TAC Xenta 102 can either be snapped onto a DIN rail (figure
3.1) or fastened with two screws to a level surface (figure 3.2).
On the controllers which controls equipment with 230 V supply,
a semi-protection which covers the relay terminals, should be
fitted (figure 3.3). A semi-protection is delivered together with
these controllers.
To fasten the controller onto a DIN rail:
1. Place the controller on the top of the rail as is shown by ar-
row 1.
2. Turn the controller downwards until it snaps onto the rail as
is indicated by arrow 2.
3. To remove, place a screwdriver in the lock on the bottom of
the controller and pull down. Then it is possible to lift the
controller diagonally upwards and off the rail.
Figure 3.1 TAC Xenta 102 fastened on a DIN rail