www.tacautoparts.com Page 4 of 5 Rev. 10/21/22 (NL)
Select the Driver/Left Side Step.
NOTE:
The
Driver/Left Side Step will have a
Sticker
“D”
on
the front.
Insert (6) 6mm T-Bolts into the channels
in the bottom of the Side Step,
(Fig 12)
, (3 T-Bolts
per channel). Attach the Step to the (3) Mounting
Brackets with (6) 6mm Flat Washers, (6) 6mm
Lock Washers and (6) 6mm Hex Nuts,
(Fig 13)
.
Do not tighten hardware.
STEP 7
Properly level and adjust the Side Step and fully
tighten all hardware.
2009-12 models requiring drilling through
pinch trim
:
a.
Level the Side Step to the vehicle. Make sure
all (3) Brackets are tight against the bottom of
the body panel and tighten all mounting
hardware.
b.
Mark the location of the slots onto the pinch
weld.
c.
Drill (2) 1/4” holes through the pinch weld for
each Bracket.
IMPORTANT
: Do not drill too
close to the bottom edge of the pinch weld.
Drill the holes in the center of the marked
slots.
d.
Repeat
Step 3
to attach the Brackets to the
drilled holes in the pinch weld. Check for level
then fully tighten all hardware.
STEP 8
STEP 6
Move to the rear location,
(Fig 11)
. Repeat
Steps
1-4
to attach (1) Driver/Left Center/Rear Mounting
Bracket
(#3)
and (1) Driver Side Center/Rear
Support Bracket
(#6)
to the Driver/Left rear
mounting location.
(Fig 11) Driver/left rear mounting location
Rear
FIG 11
(Fig 12) Insert (6) 6mm T-Bolts into the channels in
the bottom of the Side Step, (3 T-Bolts per channel)
FIG 12
(Fig 13) Attach the Driver/Left Side Step to the (3)
Mounting Brackets
(2) 6mm Flat Washers
(2) 6mm Lock Washers
(2) 6mm Hex Nuts
FIG 13
