Tabor Electronics 5064, Руководство пользователя

Страница: 133 / 369

2074
User Manual
3-62
3. Auxiliary functions disables waveform generation
When the auxiliary counter/timer function is selected, all operations
of the waveform generator are purged. Do not expect from the 2074
to make counter measurements and at the same time have signals
at output connectors.
Using the Half
Cycle Waveforms
Half Cycles is a special case of the standard waveforms except the
waveforms are generated half cycle at a time, displaced by a delay
time that is user programmable. In continuous mode, the half cycles
are generated continuously. In triggered mode, each half cycle is
generated only after a valid trigger signal is sensed at the trigger
input connector. The half cycle waveforms can also be triggered
from remote.
Accessing the half
Cycle Menus
1. There are three half cycle waveforms that can be generated:
Sine, Triangle and Square. Use the instructions below to access
and select the digital patter mode and its associated data
source.
2. Press TOP to display the root menu.
3. Press the arrow down key once and observe that the Auxiliary
Functions menu appears.
4. Press the Auxiliary Functions soft key and scroll down to
highlight the Half Cycle option, as shown in Figure 3-38.
5. Press the Enter button to select the half cycle function Figure 3-
39 shows the half cycle panel and menus.
1
2
3
4
Figure 3-38, Accessing the Digital Pattern Menus