TAB-Austria Golden Island VC2, Руководство оператора

Страница: 9 / 69

Short Instructions
Program Update
Every machine is delivered pre-programmed, when changing to a new software an update
must be carried out.
Update at Machine
The “
Golden Island
” software is on the installed HDD in the PC of the machine. The update is
done by copying the update HDD in the plug connector to the installed HDD. In some
configurations the plug connector is plumbed and an update can only be made by opening the
plumb and docking the update disk via an IDE cable within the PC box.
Important:
During an update the PC must be an integral part of the machine.
Furthermore the machine
(e.g. VC2, Strato-Steel, Cosmo or Nevada) must be connected to the
correct cable harness. The cable harness is then detected automatically by the update program
and the correct software is installed.
Procedure:
•
Switch machine off.
•
Dock the update HDD to the plug connector of the PC.
•
Switch machine on.
•
If the update tool finds an activated operator switch, you may choose for additional
update options.
•
Copy procedure is started automatically.
•
The internal hard disk is checked and if necessary newly setup.
This can lead to a restart of the machine.
•
Turn machine off at final message “Update finished – Please switch off, remove update
disk and switch on again“ .
•
Test function is started automatically (duration approximately. 1-2 min., procedure is the
same as copying) .
•
Wait for final message “Initialization complete – Please press Restart to finish” or wait 30
seconds for automatic restart of the machine.
•
After initial setup a touch screen calibration is started automatically.
•
Calibrate touch screen or wait 30 seconds for automatic finish without new calibration.
•
Update process is finished when game software is started.
Page 9