Timer Front Panel:
User Settings:
Initially the Digital Timer will show
A. To set Time and Start timer:
Step1:
Long Press SET key to enter into time setting
mode. Timer will show
Step2:
Seconds side will start blinking. Use UP/DOWN
key to set seconds.
Step3:
Press SET key to save seconds and enter to set
minute.
Step4:
The minute side will start blinking. Use
UP/DOWN key to set minutes.
Step5:
Press SET key to save minutes and exit Time
setting mode. The Digital Timer will show
Step6:
Press START/RESET key to start count.
B. To display number of successful counts:
Note*
this will only show when at least 1 time count is
successfully done and when timer is in rest position.
Step1:
Press DOWN/COUNT KEY.
C. To reset timer.
1.
By long
Pressing START/RESET while count is in
process the timer resets to target value.
SAFETY PRECAUTIONS:
All safety related codifications, symbols and
instructions that appear in this operating manual or
on the equipment must be strictly followed to ensure
the safety of the operating personnel as well as the
instrument.
If the equipment is not handled in a manner
specified by the manufacturer it might impair the
protection provided by the equipment.
CAUTION:
Read complete instructions prior to
installation and operation of the unit.
WIRING GUIDELINES:
1.
To prevent the risk of electric shock power supply
to the equipment must be kept OFF while doing
the wiring arrangement. Do not touch the
terminals while power is being supplied.
2.
To eliminate electromagnetic interference use
short wires with adequate ratings; twists of the
same in equal size shall be made. For the input
and output signal lines, use shielded wires and
keep them away from each other.
.