ARES-G2 Getting Started Guide
Page 76
Power Supply Maintenance
The only maintenance procedure that you can perform for the power supply units is to use a vacuum to
remove dust and debris from the fans on the rear of the units. Call TA Instruments if any other service is
required.
LN2 and Forced Convection Oven Maintenance
There are no maintenance procedures that you can perform for the LN2 cooler or the oven. To maintain
LN2 Controller transfer line effectiveness the LN2 Controller should be run at least once every two months
to insure optimal performance. Call TA Instruments if service is required.
Cleaning the Instrument
If the exterior plastic or metallic surfaces of the instrument require cleaning, use only a solution consisting
of a non-abrasive household dish detergent and water.
Clean as follows:
1
Remove AC power to the instrument as follows:
a
Turn the power switch on the lower power supply module to the Off (O) position.
b
Remove the power cable leading to lower power supply module from the wall outlet.
2
Apply some cleaning solution onto a cotton cloth, then wring out the cloth to discharge excess water;
the cloth must be damp, but not wet.
3
While ensuring that excess fluid from the cloth does not enter any crevice of the instrument, use the
cloth to gently clean the desired external surfaces.
4
Ensure that all surfaces of the instrument are dry.
5
Apply AC power to the instrument as follows:
a
Plug the power cable from the lower power supply module into the wall outlet.
b
Turn the power switch on the lower power supply module to the On (|) position.
Cleaning the Touch Screen
You can clean the touch screen as often as you like. The touch screen should be cleaned with a household
liquid glass cleaner and soft cloth. Wet the cloth (not the touch screen) with the glass cleaner, and then
wipe off the touch screen and surrounding surfaces.
WARNING: Do not use harsh chemicals, abrasive cleansers, steel wool, or any
rough materials to clean the touch screen, as you may scratch the surface and
degrade its properties.
AVERTISSEMENT: N'utilisez pas de produits chimiques agressifs, de nettoyants
abrasifs, de la laine d'acier ou tout autre matériau rugueux pour nettoyer écran
tactile, car vous pourriez égratigner sa surface et dégrader ses propriétés.
