ARES-G2 Getting Started Guide
Page 63
Chapter: 3
Use, Maintenance, & Diagnostics
Using the ARES-G2
All ARES-G2 experiments follow the general outline below. In some cases, not all of these steps will be
performed. The majority of these steps are performed using the instrument control software. The instruc-
tions needed to perform these actions can be found in the online help in the instrument control program;
therefore, they will not all be covered in detail here.
•
Calibrating the instrument.
•
Selecting and preparing the sample.
•
Selecting and installing the appropriate geometry for the desired test and sample.
•
Creating or choosing the test procedure and entering sample and instrument information through the
TRIOS instrument control software.
•
Loading the prepared sample.
•
Starting the experiment.
•
Displaying and analyzing results.
•
To obtain accurate results, follow all instructions carefully.
For detailed information, refer TRIOS software online Help.
Before You Begin
Before you set up an experiment, ensure that the ARES-G2, the environmental unit, and the TRIOS soft-
ware have been installed properly. Make sure you have:
•
Made all necessary cable connections from the ARES-G2 to the computer and to the modular power
supplies.
•
Connected all gas lines (air bearing and air cool).
•
Connected your environmental units.
•
Powered up the unit.
•
Become familiar with the TRIOS software.
