54561 54561
Step 4
Trim four mounting tabs on each end of the grille (4); do not cut into the face of the grille.
Step 5
The lower section on the factory mesh insert is re-used. This portion contains the metal clips to secure the grille to
core support. Use a jig-saw or die grinder to cut these sections from the insert (5 & 6); Make your cuts at the base
of the honeycomb (where it meets the solid plastic portion). Re-install.
Step 6
Position the center mesh grille in front of the grille opening. Install the 135’ flange brackets along the top (7);
install the J hook brackets along the bottom (8). Use the washers and nuts to secure each stud.
Step 7
The side inserts attach to the mounting studs on each end of the grille (9). Test fit the inserts; if necessary, bend
the brackets for optimum fit. Use the nuts and washers to secure the inserts.
Step 8
Optional; the Ford logo and mounting plate can be removed if desired. For installation, trim the thin area on the
two mounting tabs; leave 1/16” (10) material to center the logo onto the plate. Loosen the mounting plate
hardware; center the logo upright. From back, install provided fender washer, then OE retaining nut. Re-tighten
mounting plate hardware. Re-install the grille assembly onto the vehicle.
Thank you for purchasing a T-Rex
Billet Grille.
4/20/07
PAGE 2 OF 2
4
5
6
7
8
9
10
