T.I.P. HWW 1000/25 Plus F, Руководство по эксплуатации

Страница: 13 / 152

2
Notes and instructions with the following symbols require particular attention:
Any non-observance of these instructions involves the danger of bodily harm to people and/or
damage to property.
Any non-observance of this instruction bears the risk of an electrical shock which may cause
damage to persons or property.
Please inspect the device for damage occurred during transportation. In case of damage, the retailer has to be
informed immediately, at the latest within 8 days after the date of purchase.
2. Technical Data
Model HWW 1000/25 Plus F HWW 1000/25 Plus TLS F
Mains voltage / frequency 230 V~ / 50 Hz 230 V~ / 50 Hz
Nominal performance 800 Watt 800 Watt
Protection type IPX4 IPX4
Suction port 30.93 mm
(1“), female
30.93 mm
(1“), female
Pressure port 30.93 mm
(1“), female
30.93 mm
(1“), female
Max. flow rate (Q
max
)
1)
3,300 l/h 3,300 l/h
Max. pressure 4.6 bar 4.6 bar
Max. delivery height (H
max
)
1)3)
46 m 46 m
Max. suction height 9 m 9 m
Volume of the pressure tank 22 l 22 l
Max. size of the solids being pumped 3 mm 3 mm
Max. permissible operating pressure 6 bar 6 bar
Min. ambient temperature 5 °C 5 °C
Max. ambient temperature 40 °C 40 °C
Min. fluid temperature 2 °C 2 °C
Max. fluid temperature (T
max
) 35 °C 35 °C
Max. cut-in frequency in one hour 40, evenly distributed 40, evenly distributed
Length of connection cable 1.5 m 1.5 m
Cable type H05RN-F H05RN-F
Weight (net) 12.7 kg 12.9 kg
Guaranteed sound power level (L
WA
)
2)
81 dB 81 dB
Measured sound power level (L
WA
)
2)
77,4 dB 77,4 dB
Sound pressure level (L
pA
)
2)
69.4 dB 69.4 dB
Dimensions (L x D x H) 55 x 27 x 55 cm 55 x 27 x 55 cm
Item no. 31144 31141
1)
2)
3)
The values were determined with free, unreduced in- an outlet.
Noise emission values obtained according to the EN 12639 regulation. Measurement method according to EN ISO 3744.
Due to the factory pre-set switch off pressure of the pressure switch, pressure is limited to approx. 3 bar (30 m delivery head). The
theoretically achievable pressure of the pump unit of the domestic water supply can reach the v
alue specified under “Max pressure”.
Consult a qualified specialist, to adapt the pressure circuit to your requirements if necessary, see also the chapter “Setting the pressure
switch”.
3. Range of use
Booster sets from T.I.P. are self-priming electrical pumps with a mechanical or electronic pump control system for
automated operation. These high-quality products with their convincing performance data were developed for the
various purposes involved with irrigation, domestic water supply and pressure boosting, as well as for discharging
water at a constant pressure. The devices are suitable for pumping clean, clear water.
The typical areas of use of booster sets include: Automatic domestic water supply with grey water from wells and
cisterns, automated irrigation of gardens and garden beds and sprinkling, pressure boosting within the domestic
water supply system.
The device is not suitable for use in swimming pools or for installation in public water mains.
This product is intended for private use in the home area and not for commercial or industrial purposes or for
continuous circulating.
The pump is not suited to discharge saltwater, faeces, inflammable, etching, explosive or
other hazardous liquids. Please observe the max. and min. temperatures of the liquids to be
discharged stated in the technical data.
10