T+A SADV 1245 R, Руководство пользователя

Страница: 52 / 54

52
Problem: If the SADV 1245 R is connected to a
TV set directly using a SCART lead,
this can result in a scrolling DVD
picture appearing on all programme
memories. This problem may occur
with many types of TV.
Cause:
The TV set is analysing the A/V switching
signal from the DVD player incorrectly, or
not at all.
Remedy 1: If possible, call up the Setup menu for
your TV set and switch off RGB priority.
Select the RGB signal type for the DVD
SCART input of your TV set.
Remedy 2: If your television does not provide this
option, connect the DVD player using an
S-VHS lead, or use a SCART lead without
RGB signal. Ask your
 dealer for help
with this.
Remedy 3:
When watching TV, switch off the DVD
player by pressing the

 
 button on
the front panel.
Problem:
When used in a non-

system the
machine does not respond to remote
control commands, or cannot be
switched on by remote control.
Cause: E 2000 remote control receiver not con-
nected.
Remedy: Connect the E 2000 remote control
receiver as shown in Wiring Diagram 3 .
Press the source select button 
 

(or     ) on the remote control handset
to switch the machine on.
Problem: When operating the menu for the surround
decoder
or surround receiver, the
SADV 1245 R also responds.
Cause: E 2000 connected to the SADV 1245 R .
Remedy:
Connect the E 2000 to the pre-amplifier,
integrated amplifier or receiver.
Problem: MP3 CD does not play back.
Cause: MP3 format not supported
(see
' Playing MP3 CDs ' ).
Remedy: (see ' Playing MP3 CDs ' )
Problem: Distorted or double picture at the YUV
output
Cause: P-Scan switched on buit TV set not
compatible with progressive video signals
Remedy:
Switch P-Scan off (

 

button on the
front panel).
Problem: No picture.
Cause: Video-output switched off
Remedy:
switch ON the video output (    
button on the front panel)
Problem: Bad or distorted sound reproduction
Cause 1: Multi channel mode is selected but only a
stereo amplifier is connected
Remedy: switch to STEREO in the menu
' Preference / Sound / Analog output '
Cause 2: a multi channel amplifier is used but it is
switched to STEREO operation mode
Remedy: switch the surround-amplifier to multi
channel mode
Problem:
' overheat overheat overheat overheat ' displayed, playback stopped
Cause: Device is over heated, too little flow of
cooling air
Remedy:
change the installation of your system to
provide sufficient cooling.
do not place the SADV 1245 R on top of
hot equipment like amplifiers or surround
receivers
Problem: Not possible to switch to MCH mode
Cause: Disc does not contain a multi channel
layer
Remedy: no remedy, disc can only be played back
in Stereo.
Problem: The 'WIDE'-mode can not be selected
Cause: switch 'WIDE' at the back panel is set
position 'Disable' .
Remedy: Set switch to position 'Enable' .
Problem: Discs can not be played. A message to
enter a PIN appears.
Cause: This disc is locked
Remedy: Enter a valid PIN number or unlock the
disc (see menu
' Setup / Access ' ).
Note:
In case you have forgotten your PIN
number, enter the menu
' Setup / Access /
Enter PIN ' . Enter the input box on the
right and press the

 

-button four
times (the on screen display will show the
“forbidden” icon). Then enter 0000 twice.
The PIN is now reset to to 0000.