T+A DAC 200, Руководство пользователя, Страница: 55 / 64

System settings
Meter mode
Under this menu item the display mode of the meters can be set.
The following measurement types are available:
Input level - Level of the input signal
Output level - Level of the output signal
Temperature -
Temperature monitor of the device and the
Class A output stages
Signal quality
- Displays the quality (frequency deviation and error rate) of
the input digital signal.
Meters off -
Meters switched off
j
For detailed information on the various meter settings and display types, refer to chapter
Meters
on page 48.
Source
configuration
Under this menu item, sources which are not needed can be deactivated.
Deactivated sources can no longer be called up using the source buttons on the device
and the remote control.
After calling up this menu item with the
button, a list of all sources of the DAC 200
appears.
Each source is followed by a remark indicating whether the source is activated (ena-
bled) or deactivated (disabled).
PRE Output
This menu item allows you to set the analog outputs (ANALOG OUT 1 and 2) to a fixed
output level (LINE), or to an variable output level (VARIABLE) that can be adjusted using
the volume buttons on the remote control and the volume knob on the DAC 200.

For operation in combination with active loudspeakers or a power amplifier, e.g. the
A 200, use only the
VARIABLE
setting.
Otherwise, it may lead to overloading and resulting damage of the
connected loudspeakers.
Display
brightness
Here you can adjust the brightness of the display during normal operation to your
personal preferences in 9 steps.
Display mode
Here you can set whether the display will be switched on permanently or only tempora-
rily, when the device is being operated.
If the setting
temporary is selected, the display is switched on during operation of the
DAC 200 only and then automatically switched off again after a short delay.
If the
Always ON setting is selected, the display remains permanently on.
Colour profile
Under this menu item you can adjust the brightness of the status LEDs and the
brightness and illumination color of the meters to your personal preferences.
Select the menu item
Default colours
to reset the displays to the default settings.
55