10
©
Copyright 2006 TAC All Rights Reserved.
F-23837-5
5. Using two appropriately sized mounting screws (not provided), mount the base plate
onto the 1/4 DIN electrical box.
Note: No more than 6" (152 mm) of wire should remain under the cover.
6. Strip 1/4" (6 mm) of insulation from the ends of the wires.
7. Connect the wires to the terminal block on the base plate. See the wiring diagrams in
Figure-1 . When installing a wire in the terminal block, insert the wire from the top side
of the terminal and secure it by tightening the screw located on the front side of the
terminal block.
Caution:
To prevent damage to the components, do not use excessive force when
mounting the sensor base plate onto the electrical box.
8. Dress the wires down and inside the perimeter of the base plate.
9. If the wall plate is to be used, snap it onto the base plate.
10. Reinstall the cover by inserting its top inside edge over the tab on the base plate and
rotating the cover downward. Press the cover to snap it in place.
Figure-10
Mounting Procedure for European 1/4 DIN Electrical Box.
European 1/4 DIN
Standard Electrical Box
Cover
Terminal Block
Wire Feedthrough
Opening
Mounting Screws (2)
(not furnished)
Base Plate
Printed Circuit
Board
Cover
Latch
Sensing
Element
