7.
Automatically prompt interface
7.1 Error Code Display Error Code
Definition
01
＿
info Throttle Abnormality
03
＿
info Motor hall signal Abnormality
04
＿
info Torque sensor signal Abnormality
05
＿
info Axis speed sensor Abnormality(only applied to torque
sensor)
06
＿
info Motor or controller has short circuit Abnormality
Electronic control system failure will display (flashing) fault code. Once the fault was removed,
it automatically exits from the fault code display interface.
General Project Setting
1.
Set maximum riding speed
Within power on 5 seconds, hold
and
at the same time to
enter maximum riding speed Km/H and MXS setting, press
button
maximum riding speed flashing, then press
or
to set the
maximum riding speed (default 25Km/H). Press
button to save the
setting, and press
to the next parameter settings.
2.
Wheel diameter setting
The wheel diameter will be set after finishing setting the maximum
riding speed, press
button
wheel diameter specifications flashes.
Press
or
to set the specifications of wheel diameter. Select the
range 5,6,8,10,12,14,16,18,20,23,24,26,27.5,700c,28and 29 inches. Press
button to save and press
to go to the next parameter settings.
3.
Set the metric units
The metric units will be set after finishing setting wheel diameter,
press
button UNT flash. Press
or
to select the three
metric units of speed, mileage, and ambient temperature in
synchronization.
Display
Metric
Imperial
Riding speed
Km/H
MPH
Total distance
Km
Mil
Environment temperature
℃
Temperature
℉
Fahrenheit
4.
Press
button
UNT stop flash after metric unit setting is completed. Hold
button long
to exit from setting environment of routine projects and save the setting values, returning to
display
5.
Exit from routine project setting
All three routine project settings can exit from the setting environment and return to the
display by holding
button long after each setting is completed, meanwhile the setting values
are saved.
Under each setting interface, if the button failed holding for more than 1 minute, it will
automatically return to display 1, and the setting value is invalid.
Outline Drawings and Dimensions
1.
Dimensions of main instrument body
2.
Mounting dimensions of double brackets
3.
Wiring diagram
