•
Do not use the hair clipper when the skin is infected.
•
Do not use the hair clipper on animals.
•
The manufacturer reserves the right to introduce minor changes into the product design without prior
notice, unless such changes influence significantly the product safety, performance, and functions.
BLADE ALIGNMENT
•
Your clipper was carefully examined to ensure that the blades were oiled and properly aligned
before leaving our factory.
•
Blades must be realigned if they were removed for cleaning or after replacement.
•
To realign the blades, simply match the upper and lower blades teeth up, point for point.
•
End of top blade teeth should be approximately 1.2 mm back from lower blade.
•
If blade alignment is incorrect, add a few drops of oil to the blades, switch on the clipper for a few
moments, switch off and unplug. Loosen screws slightly and adjust. Tighten screws after blade is
aligned.
OILING
•
To maintain your clipper in peak condition, the blades should be oiled after every haircut.
•
Do not use hair oil, grease, oil mixed with kerosene or any solvent.
BLADE LEVER
•
The lever located to the left of the blades, allows easily adjust cut hair length while clipping.
•
The lever adds versatility to your clipper by allowing you to gradually change the closeness of your
cut without an attachment comb.
•
When the lever is in the uppermost position, the blades will give you the closest cut and leave the
hair very short. Pushing the lever downwards gradually decreases the cutting length (less hair will be
cut).
•
In its lowest position, the lever will leave the hair approximately the same length as a 1 (3mm) comb.
•
The lever will also extend the use of your blades since a different cutting edge is used in each
setting.
If extremely heavy hair cutting has jammed the blades, follow the steps below to remove the hair without
removing the blades.
•
While the clipper is running, rapidly move the lever from "close cut"± to "longer cut"± a couple of
times.
•
Do this each time after you have finished using your clipper to keep the blades free of cut hair.
•
If this does not help and clipper stops cutting, blades are dulled. Replace them with new blades.
INSTRUCTIONS FOR HAIR CUTTING
•
Before starting the hair cut inspect the clipper, making sure that there is no oil between the cutting
blade teeth, switch the unit on to distribute the oil between the blade teeth and to check running
smoothness. Wipe off any excess oil. This should be done after each use. While using the unit,
untwist the cord from time to time to avoid tangling.
•
Before cutting always comb the hair thoroughly first.
DETACHABLE COMBS
Attachment comb
Hair length (mm)
1
3
2
6
3
9
4
12
Each comb attachment is marked accordingly on its outside middle surface.
•
To attach a comb, hold it with its teeth upward and slide onto and along the clipper blade until the
front of the comb firmly seats against the clipper blade.
•
When you use the clipper for the first time, cut only small portions of hair.
•
For even cutting do not force the clipper. Also remember to comb the hair more frequently to remove
trimmed hair and check for uneven strands.
CARE AND CLEANING
•
Before cleaning, make sure to switch off the appliance and unplug it.
•
Clean and oil the appliance after each use.
•
Remove cut hair from the clipper with the brush enclosed.
•
Wipe the clipper with a dry soft cloth.
•
Oil the blades as mentioned above.
