SystemAir prio 150E2, Инструкция по установке и эксплуатации, Страница: 12 / 14

8 | Maintenance
4.1 Commissioning
Danger
• All electrical connections must be carried out by an authorized installer and in accordance with local rules
and regulations.
Before initial operation, check the following:
• Electrical connection has been properly completed.
• Protective earth has been connected.
• Safety devices in place (protection grid).
• Leftover installation materials and foreign materials have been removed from the casing.
Testing the installation:
• Adjustment may be required in the electrical compartment during test (i.e. changing of the potentiometer), however
during operation the lid must be closed.
When putting into operation, check the following:
• Smoothness of motor operation, (no abnormal noises).
5 Maintenance
5.1 Important
Danger
• Make sure that the mains power supply to the unit is disconnected before performing any maintenance
or electrical work!
• Fan impeller has come to a complete standstill.
• The unit is heavy. Be careful during transport and installation. Risk of injury through pinching. Use
protective clothing.
• Do not lift the fans by the connecting cable, connection box, motor bracket, impeller or inlet cone.
5.2 Cleaning the fan
Warning
• Make sure that the mains power supply to the unit is disconnected before performing any maintenance
or electrical work!
• Fan impeller has come to a complete standstill.
Caution
• Beware of sharp edges during maintenance, use protective gloves. Risk of injury through pinching.
The fan should be cleaned when necessary, at least once a year to avoid imbalance and unnecessary damage to the
bearings. The fan bearings are maintenance free and should only be replaced if damaged. Do not use a high-pressure
cleaner (steam jet) when cleaning the fan. Ensure that the fan impeller's balance weights are not moved or the fan im-
peller distorted. Listen for abnormal operating noise.
6 Troubleshooting
The following applies in case the fan has stopped:
• Try to restart the fan by cutting the power a couple of minutes.
• Ensure that the impeller is not locked. Disconnect the power supply, remove any obstacles. Check that the fan starts
after reconnecting the current. Should the fan not start please contact your place of purchase.
7 Deinstallation/dismantling
Deinstall and dismantle the fan in reverse order of installation and electrical connection
| 002